Skip to main content

PERIODICITY

Post a Comment

REDUCTION OF ALDEHYDES AND KETONES

reduction of aldehydes and ketones to alcohols, reduction of ketones, reagents used for reduction of aldehydes and ketones, reduction of ketone to alcohol REDUCTION OF ALDEHYDES AND KETONES


Comments

Post a Comment

Popular posts from this blog

PROPERTIES OF THE PERIOD 3 CHLORIDES

This page looks at the structures of the chlorides of the Period 3 elements (sodium to sulphur), their physical properties and their reactions with water. Chlorine and argon are omitted - chlorine because it is meaningless to talk about "chlorine chloride", and argon because it doesn't form a chloride. A quick summary of the trends The chlorides The chlorides we'll be looking at are: NaCl MgCl 2 AlCl 3 SiCl 4 PCl 5 S 2 Cl 2 PCl 3 There are three chlorides of sulphur, but the only one mentioned by any of the UK-based syllabuses (A level or its equivalents) is S 2 Cl 2 . As you will see later, aluminium chloride exists in some circumstances as a dimer, Al 2 Cl 6 . The structures Sodium chloride and magnesium chloride are ionic and consist of giant ionic lattices at room temperature Aluminium...
Post a Comment
Read more

CHEMICAL REACTIONS OF THE PERIOD 3 ELEMENTS

This page describes the reactions of the Period 3 elements from sodium to argon with water, oxygen and chlorine. Reactions with water Sodium Sodium has a very exothermic reaction with cold water producing hydrogen and a colourless solution of sodium hydroxide. Magnesium Magnesium has a very slight reaction with cold water, but burns in steam. A very clean coil of magnesium dropped into cold water eventually gets covered in small bubbles of hydrogen which float it to the surface. Magnesium hydroxide is formed as a very thin layer on the magnesium and this tends to stop the reaction. Magnesium burns in steam with its typical white flame to produce white magnesium oxide and hydrogen. Note:   If you are heating the magnesium in a glass tube, the magnesium also reacts with the glass. That leaves dark grey products (including silicon and perhaps boron from the glass) as well as the white magnesium oxide. Not...
Post a Comment
Read more

ANALYTICAL TECHNIQUES High Resolution Mass Spectrometry Infra-red Spectroscopy

Topic 2.11 ANALYTICAL TECHNIQUES High Resolution Mass Spectrometry Infra-red Spectroscopy HIGH RESOLUTION MASS SPECTROMETRY The technique of mass spectrometry was used in Unit 1 to: a)       determine the relative abundances of different isotopes in a sample of an element and hence to deduce relative atomic masses b)       identify the peak with the largest m/z ratio in a spectrum of a molecule and hence determine the rmm of the molecule On closer inspection of the molecular ion peak, it is actually possible to reveal more information than just the relative molecular mass. If the mass spectrum is examined under high resolution, the complete molecular formula can be deduced. Eg        If an organic molecule is found to have a molecular ion peak of 58 in a mass spectrometer, it could be eithe...
Post a Comment
Read more